Encyclopedia

of Home Improvements

*Making Butt Joints*

Making Butt joints is simple with a biscuit joiner

Unplug the biscuit joiner

Place the two pieces of wood to be joined on a level workbench. Align them against each other in the arrangement in which they will be assembled.

Using a square, determine the location of each biscuit spline joint and mark the center of each joint by drawing a line across the edges of the two boards. (photo10)
.
Loosen the locking knob and set the fence angle at 90°.

Set the fence height at the desired dimension on the scale by rotating the height adjustment knob. Note: The scale indicates the height of the fence from the center of the blade.

Tighten the locking knob securely.

Select the correct depth of cut setting to match the biscuit size you are planning to use. Make a test cut in a scrap piece of wood from the same workpiece if possible.

Clamp the workpiece securely so that will not move during the cut.

Plug the biscuit joiner into a power supply and prepare to make your first cut. Grasp and hold the biscuit joiner securely with both hands.

Place the fence against the board and align the indicator mark on the fence with the centerline mark(s) on the board. (photo11)

Depress the switch trigger to turn on the biscuit joiner, and then push it forward to extend the blade into the wood.

When the base assembly bottoms out against the depth of cut adjustment knob setting, pull back to release pressure on the spring. The blade will retract from the biscuit slot.

Repeat this procedure for cutting the slot in the mating workpiece.

Once all biscuit slots have been cut, place a biscuit in each butt joint and dry assemble the workpieces. Make sure each joint lines up and fits.

Finally, disassemble the workpieces and place a bead of glue in each slot. (photo12)Also, spread a bead of glue over the entire surface of the butt joint. Reinsert the biscuits and assemble the workpieces as shown

Clamp the butt joints together until the glue sets up. (photo13)

Back to Topics Page

Contact